What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
Last Updated: 27.06.2025 07:59
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
The third is lightning and “how it gets conducted into a home.”
What is lightning?
Sea spiders found farming methane-eating microbes in cultivated biofilm - Phys.org
One is “what exactly is in a ‘surge protector’ ? ”
(Dc diagram shown, AC is similar).
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
This one hit behind the barn.
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
2024–10–10[John johnson John Johnson ]
It seems Mohan does not understand the difference between a comment and an Answer.
Pure Orwell: Europe condemns Iran for attacks on its own territory - Responsible Statecraft
An AC voltage/ current source, and an ac inductive load.
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
Because the load is inductive, the current lags the voltage.(by a bit).
Here is a simplified AC power diagram.
I post the exact comment here.
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
In schematic diagrams this is the symbol for a fuse:
[old diagram got deleted by accident]
At one ohm, the resistor has a maximum of 1 watt power.
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
He then describes Rainy Season and Lightning.
This is where the MOV conducts again, and dissipated the energy.
Bucheron and Myriel’s Karyn Tomlinson win James Beard Awards - Star Tribune
The MOV will conduct when the voltage exceeds 50% of line voltage.
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
but I think this circuit , shows a few more pieces.
This is where this question deviates from being a 'generic' question, and becomes more specific.
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
This is 'the assistant's answer'
Exclusive | New York to Build One of First U.S. Nuclear-Power Plants in Generation - WSJ
A circuit breaker is similar, but is resettable.
But it can get overloaded, and no longer works.
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
The other is “what does a “fuse” do?”
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
Barnstars:
71-year-old man makes history with world record for bench pressing - 11Alive.com
2024–10–16 [ OO OLAOYE OYEBODE ]
So, the voltage could go up to 500 volts, and the fuse will not open up.
These devices are installed between the “hot” and “neutral” and protective ground.
eight
There are two important concepts here.
but this device (an Inductor) … impedes the rapid changes in the current.
so, what happens?
The bolt then partially travels down the line to your home.
First Sentence:
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
the problem then depends on "how fast does the fuse operate?".
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
a photo is worth a thousand words.
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
These are simplified answers to the original question, and does not change anything I wrote above.
Can the fuse protect the electronic devices from lightning instead of a surge protector.
[image of Common-mode choke]
He then asserts :
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
A fuse is a non-resetable over current circuit protector.
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
Upvotes:
what exactly is a ‘surge’ protector?
He then describes the function of a fuse.
At least they know the answer if they wanted it.
Edit 2024–10.
Now when you have a certain ac resistance, then a current flows in a loop.
This is the picture of an electronic coil of wire wound around a core of magnetic material.
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
2024–10–14 [Omar Gharbi Omar Gharbi ]
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
For this case there are devices called Metal oxide varistors (MOV).
One
What does a fuse do?
nine
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
But… the neutral is now “floating” because of the 1 ohm resistance.
There are three different concepts here that are getting confused.
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
This device then solves the entire problem.
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
It also is a device that limits the change in current flow.